How to hang an acrylic floating frame
Short answer: hold the back panel against the wall and mark the four corner holes, screw the standoff bases into the wall, peel the protective film, sandwich your print between the two panels, then slide the frame onto the bases and screw the caps on. Ten minutes with a drill and a screwdriver, and everything you need is in the box.
Forty seconds: how the frame hangs on its standoffs and how a print swaps without taking it off the wall.
What's in the box
Two clear cast acrylic panels with protective film, four standoffs (a base, a cap and a screw each), wall anchors and screws.
Step by step
- Mark the drill points. Hold the back panel where you want the frame and mark the wall through the four corner holes. Check it with a level before you drill; the holes are the one thing you can't move later.
- Screw in the standoff bases. Drill, push in the wall anchors, and screw the four bases into place.
- Peel the film. Both panels are masked on both sides. Lift each layer at a corner and peel it away now, before the print goes in.
- Add your photo. Lay the print on the back panel, centre it inside the clear margin, and set the front panel over it.
- Cap and tighten. Slide the assembled frame onto the bases and screw the caps on finger-tight.
Portrait or landscape
The frame hangs either way. Decide before you drill.
Changing the photo later
Unscrew the four caps, lift the front panel, swap the print, and cap it again. The bases stay on the wall, so the frame goes back exactly where it was.
Floating frames: 16 sizes, black, gold, silver or white standoffs